iKuai爱快流控路由
标题:
求对接思科的链路汇聚
[打印本页]
作者:
wlaizr
时间:
2023-6-27 10:38
标题:
求对接思科的链路汇聚
本帖最后由 wlaizr 于 2023-6-29 14:13 编辑
由于多个wan口,总带宽超过2g,lan是千兆的,需要汇聚lan口,求一个对接思科交换机的配置
无奈自己设置不成功
lan1设置eth6和eth7口 桥接加聚合,负载模式 mac,聚合网卡勾选eth6和7
思科3560,23-24口做的配置如图
消息来自爱快e云
作者:
雪夜流星
时间:
2023-6-27 11:08
本帖最后由 雪夜流星 于 2023-6-27 19:51 编辑
感觉你的配置没什么问题
看一下爱快这边的配置截图
en
conf t
vlan X
interface port-channel 1
switchport trunk encapsulation dot1q
switchport mode trunk
switchport trunk allowed vlan X,X
interface range g0/23-24
switchport trunk encapsulation dot1q
switchport mode trunkchannel-protocol lacp
switchport trunk allowed vlan X,X
channel-group 1 mode active
port-channel load-balance ?
show etherchanne 1 summary
show etherchanne 1 detail
或者你测试一下方案二
en
conf t
vlan X
port-channel load-balance src-dst-ip
interface port-channel 1
switchport trunk encapsulation dot1q
switchport mode trunk
switchport trunk allowed vlan X,X
interface range g0/23-24
switchport trunk encapsulation dot1q
switchport mode trunk
channel-protocol lacp
switchport trunk allowed vlan X,X
channel-group 1 mode active
爱快按照图二设置
作者:
9527
时间:
2023-6-27 14:26
您好,
下面是思科交换机二层端口聚合23、24口的命令,您参考一下;
interface Port-channel 1
exit
!
interface GigabitEthernet1/0/23
channel-group 1 mode active
exit
!
interface GigabitEthernet1/0/24
channel-group 1 mode active
exit
!
interface Port-channel 1
switchport mode trunk
switchport trunk encapsulation dot1q
switchport trunk allowed vlan all
exit
!
复制代码
作者:
xibanya
时间:
2023-6-27 14:28
本帖最后由 xibanya 于 2023-6-27 14:29 编辑
trunk都没放行vlan,协议起来了数据肯定通不了端口下加 sw tru all vlanYY-ZZ(例如10-20)
作者:
wlaizr
时间:
2023-6-28 17:12
感谢大家,已经搞好了
port-channel 上允许vlan
或者在 端口下允许vlan
欢迎光临 iKuai爱快流控路由 (https://bbs.ikuai8.com/)
Powered by Discuz! X3.3