iKuai爱快流控路由
标题:
求教 链路聚合,华为交换该怎么配置
[打印本页]
作者:
天使移动
时间:
2022-11-23 09:48
标题:
求教 链路聚合,华为交换该怎么配置
求教 链路聚合,华为交换该怎么配置
(, 下载次数: 30)
上传
点击文件名下载附件
(, 下载次数: 28)
上传
点击文件名下载附件
(, 下载次数: 39)
上传
点击文件名下载附件
作者:
xibanya
时间:
2022-11-23 10:00
1.负载分担模式不需要和爱快一致;2.华为eth-tunk编号一般为0-127,填写本地唯一数值即可;3.combo类型 缺省自动即可
作者:
whycoby
时间:
2022-11-23 10:21
本帖最后由 whycoby 于 2022-11-23 10:23 编辑
开户SSH:
interface eth-trunk 1
[SwitchA-Eth-Trunk1] mode lacp
[SwitchA-Eth-Trunk1] quit
interface gigabitethernet 0/0/1
[SwitchA-GigabitEthernet0/0/1] eth-trunk 1
[SwitchA-GigabitEthernet0/0/1] quit
interface gigabitethernet 0/0/2
[SwitchA-GigabitEthernet0/0/2] eth-trunk 1
[SwitchA-GigabitEthernet0/0/2] quit
interface gigabitethernet 0/0/3
[SwitchA-GigabitEthernet0/0/3] eth-trunk 1
[SwitchA-GigabitEthernet0/0/3] quit
....
后续端口类似
作者:
雪夜流星
时间:
2022-11-23 10:26
whycoby 发表于 2022-11-23 10:21
开户SSH:
interface eth-trunk 1
[SwitchA-Eth-Trunk1] mode lacp
有时候命令行比WEB方便多了
作者:
天使移动
时间:
2022-11-23 14:10
搞定了 华为用默认配置 爱快负载模式改为IP+端口:)
欢迎光临 iKuai爱快流控路由 (https://bbs.ikuai8.com/)
Powered by Discuz! X3.3